236 Tagging Systems Racking Safety Due to the weight, size and loads involved with modern racking it must be checked regularly to ensure the safety of staff and visitors. Our racking tag holders are a modified version of the AssetTag Max system and are designed to be fixed to the crossbeams of the racking displaying racking specific safety messages. A checklist on the insert describes the checks which must be made and includes space for inspection details to be recorded. An area is available for completion should intermediate work be required, whereas the insert should be removed totally if the racking is deemed unsafe. This will then display the ‘Do Not Use Unsafe Racking’ message pre-printed on the holder. Description Qty Code Single Insert 1 TG09-1 Pack of 10 Inserts 10 TG0910 Pack of 50 Inserts 50 TG0950 Box 10 Holder, 20 Inserts, 2 Pens TG09BOX AssetTag Racking 5 TGRK5 Description Qty Code Single Insert 1 TG11-1 Pack of 10 Inserts 10 TG1110 Pack of 50 Inserts 50 TG1150 Box 10 Holder, 20 Inserts, 2 Pens TG11BOX AssetTag Racking 5 TGMX5 10 Holders 20 Inserts 2 Pen TG09BOX 10 Holders 20 Inserts 2 Pens TG11BOX Racking Safety 75 x 180mm Polypropylene TG09-1 AssetTag Max 80 x 213 x 6mm TGMX5 AssetTag Racking 213 x 80 x 6mm TGRK5 MEWP Safety The Work at Height Regulations came into force in 2005. These regulations apply to work at height where there is a risk of fall liable to cause personal injury. It states that ‘equipment for work at height is properly inspected and maintained’. MEWPs (Mobile Elevating Work Platforms), scissor lifts, booms and cherry pickers are included under this instruction. A daily pre-work inspection should be carried out and recorded on these tags. Inserts are designed for use with the AssetTag MAX holder. The holder should be permanently fixed to the equipment in a suitable safe place. Perform an inspection (a checklist is printed on the reverse) and record the result on the tag. In the event of the equipment failing, remove insert and inform a supervisor. The holder clearly states ‘Do Not Use This Equipment’ when the tag is removed. MEWP Safety 75 x 180mm Polypropylene TG11-1 This racking requires intermediate work Caution DATE INTERMEDIATE WORK NEEDED DATE COMPLETED SIGNED RACKING SAFETYRECORD TAG INSPECTION RECORD CONTAINED ON THE INSIDE DISCONTINUE USEAND NOTIFYRESPONSIBLE PERSON IMMEDIATELYIF DAMAGE IS IDENTIFIED ON THIS RACKING ID NO.: LOCATION: No. BAYS: HEIGHT: TYPE: MAXIMUM BAYLOAD (Kgs): SUPPLIED BY: SUPPLIER TEL: SUPPLIED NEW (TICK): DATE OF INSTALLATION: INSTALLED BY: YES: NO: FRONT BACK INSPECTIONS MUST BE PERFORMED BYACOMPETENT PERSON • IF RACKING IS UNSAFE DISCONTINUE USE IMMEDIATELYREMOVE INSERTAND FOLLOW INSTRUCTIONS ON HOLDER • IF INTERMEDIATE WORK IS REQUIRED DETAILON BACK COVERAND SIGN OFF WHEN WORK IS COMPLETE DATE NAME UNSAFE INTERMEDIATE WORK REQUIRED SAFE SIGNED Unauthorised removal or interference with this tag could make you liable to prosecution and fines STRUCTURAL CHECKS LOAD CHECKS TOP (inside) BOTTOM (inside)
RkJQdWJsaXNoZXIy Mzk5NjQ=