210 Lockout Tagout Dimensions Small Large (A) height 51mm 83mm (B) width 89mm 178mm (C) depth 51mm 83mm (D) circle dia 13mm 25mm # of holes 2 4 Inner height 42mm 74mm Inner length 80mm 165mm B A C D 4. Shown with both plates in place giving a cable access hole of 10 x 15mm. Manufactured from polypropylene, the hexagon design opens up in two halves and is suitable for a variety of industrial plugs. Small Unit: Can accommodate 2 padlocks. Large Unit: Can accommodate 4 padlocks. Accepts padlocks with a shackle diameter of 7mm or less. This large electrical plug Lockout has two interlocking cover plates allowing plugs with various sizes of cable to be inserted. Interior size of 84mm dia. x 150mm and will accept cable widths up to 34mm dia. Electrical Plug Lockout Electrical Cylinder Lockout Description Code Small (4 Holes) LOK188 Large (4 Holes) LOK190 Description Code 97mm dia x 160mm LOK058 1. Shown with both plates open allowing insertion of the plug. 3. Shown with cover plate B in place giving a cable access hole of 16mm. 2. Shown with cover plate A in place giving a cable access hole of 34mm. Electrical Labels Warn of potential hazards FIND THE FULL RANGE OF ELECTRICAL LABELS FROM PAGE 176 Ensure vital equipment cannot be accessed by locking off the socket at the wall outlet. This lockout is suitable for standard UK single sockets, and can be used for switches, power sockets, network points etc. To fit, isolate the power to the outlet, loosen the screws and place the cover behind the faceplate. Re-tighten the screws pulling the cover into place. To use cover with plug sockets, turn the cover 90°. Up to two padlocks can be fitted, if more are needed consider using a suitable hasp. Note: Cable gaps are located at the side and may not be suitable for thicker/rigid cables Switch and Socket Cover Size Code Single Gang LOK215
RkJQdWJsaXNoZXIy Mzk5NjQ=